300 Second (5 Minutes) USB Recording Module with Push-Switch and White Enclosure (Windows)

This module connects to your computer via a USB cable. Then use the free software to record up to 300 seconds of .wav and/or .mp3 files to it. The software is very powerful and will allow you to stack wave files and program pauses so the same button can be used to trigger up to 200 different messages! (The messages are played sequentially each time the PUSH-BUTTON is pressed) Comes with a built-in speaker. Features: Up to 300 seconds of re-recordable voice message (4.7K sample rate) Includes 6 different playback settings including repeat and continuous playback Use USB type-B male connector for direct plug into USB cable Easy to transfer software for windows of .WAV or MP3 audio files Range of 4K - 20K sample rate. 300 seconds non-volatile recordable IC. Operating Voltage 3 to 5 V DC (3 x AA batteries not included) Operating Current <50 mA Standby Current <5 uA Front push switch playback 57mm built-in speaker, Rated Power 0.25w, Peak Power 0.5w, 16 Ohm Dimensions: 65 x 94 x 26mm Unused USB port on computer Windows 7 or later (Not Mac compatible) 3 x AA Batteries (Not included) PM66Q Software must be downloaded from sellers website

• Recording Capacity: Up to 300 seconds of re-recordable voice message with 4.7K sample rate for clear audio playback
• Versatile Playback Options: Includes 6 different playback settings including repeat and continuous playback modes
• Windows Compatible Software: Easy to transfer software for Windows allows uploading of .WAV or MP3 audio files. Only Windows compatible, not Mac
• Power Requirements: Operating Voltage 3 to 5 V DC, requires 3 x AA batteries which are not included
• Energy Efficient Design: Standby Current less than 5 uA for extended battery life
• Built-in Speaker System: 57mm built-in speaker with Rated Power 0.25w, Peak Power 0.5w, and 16 Ohm impedance
• Ready to Use: Skill level is assembled and tested, arrives ready for immediate use with push-button activation